Get Quote

Ningbo Kingvos Electrical Appliance Co.,Ltd

Removing glue from a hot melt glue guns--Kingvos Electrical

2015 10/21

1.Plug in the hot glue gun and then turn it on if it has a switch. Most turn on when you plug them in. Allow the glue gun to heat up.

2.Load a glue stick into the gun and pull the trigger. Use the new glue stick to help push out as much of the old stick as you can. If you can, push out the entire old portion and pull the new stick back out with your fingers. If you push it in too far during use, you won't be able to do this, so watch the stick and make sure it doesn't go too far.

3.Use a metal stick, such as a paperclip pulled out straight, to scrape out the nozzle of the glue gun. Do this if the glue is old and doesn't flow well. This also works to get the remaining glue out that can't be pushed out from behind. Wipe the nozzle on a paper towel to clean it off.


43

Browse by: All Products | China Suppliers Service is provided by Bossgoo.com

Copyright © 2008-2024 Bossgoo Co., Ltd. All rights reserved.

Your use of this website constitutes acknowledgement and acceptance of our Terms & Conditions